| 梁召峰.压电陶瓷堆位置对郎之万换能器内部损耗的影响[J].声学技术,2017,36(2):188~191 |
| 压电陶瓷堆位置对郎之万换能器内部损耗的影响 |
| Influence of piezoceramic stack location on internal losses of Langevin transducer |
| 投稿时间：2016-08-15 修订日期：2016-11-07 |
| DOI：10.16300/j.cnki.1000-3630.2017.02.016 |
| 中文关键词: 郎之万换能器 压电陶瓷 机械损耗 介电损耗 |
| 英文关键词: Langevin transducer piezoceramic mechanical loss dielectric loss |
| 基金项目:国家自然科学基金（11304207）、广东省自然科学基金（S2012010010402）、深圳市基础研究项目（JC201006020762A）资助 |
|
| 摘要点击次数: 1573 |
| 全文下载次数: 1276 |
| 中文摘要: |
| 压电陶瓷堆位置是郎之万换能器优化设计的一个重要对象，人们对其研究较多但结论并不一致。文章主要考虑压电陶瓷的机械损耗及介电损耗，分析了恒振幅输出时这两种损耗与压电陶瓷堆位置的关系，并通过引入负载系数探讨了不同负载情况下压电陶瓷堆位置对郎之万换能器内部损耗的影响。分析结果表明，对于不同的负载，压电陶瓷堆均对应一个最佳位置，此时换能器的内部损耗最小，且随着负载的增大，这一最佳位置逐渐向换能器的节点位置靠近。可见，压电陶瓷堆位置的优化设计与实际负载密切相关，以往关于该问题的不同结论源于其仅针对某种特定负载分析而得。 |
| 英文摘要: |
| Piezoceramic stack location is an important optimization design object of Langevin transducer, and many researches on this topic have been done but there are no consistent conclusions. In this paper, mechanical loss and dielectric loss of piezoceramic are mainly considered, and the relation between these two kinds of losses and the piezoceramic stack location is analyzed under the circumstances of constant output amplitude. Moreover, by introducing the load coefficient, the influence of the piezoceramic stack location on internal losses of Langevin transducer is discussed under different load conditions. The results show the piezoceramic stack corresponds to a best location for different loads, and at this time the internal losses of Langevin transducer is the smallest. The best location is gradually close to the displacement node of the transducer as the load increases. Thus it can be seen that the optimal design of piezoceramic stack location is closely related to the actual load, and the inconsistent conclusions about the problem by far stem from these analyses only to specific loads. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
